Table of Contents
Advertisement
TROUBLESHOOTING
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
LED does not blink when you press a key.
Replace batteries with four new AAA alkaline
batteries.
LED blinks when you press a key, but home enter-
tainment component does not respond.
Make sure the remote control is aimed at your home
entertainment device and is not farther than 15 feet
away.
The unit does not control home entertainment devices
or commands are not working properly.
Try all listed codes for thecomponent brands being
set up. Make sure they can be operated with an
infrared remote control.
TV/VCR combo does not respond properly.
Use the VCR codes for your brand. Some combo
units may require both a TV code and a VCR code
for full operation.
Changing channels does not work properly.
If original remote control required pressing ENTER
to change channels, press
control after entering the channel number.
Tried "Search Method" and still could not find a
working code.
Clear the device key as follows: Press and hold
until the LED blinks twice, then release. Next enter
-
-
. Then press the device key to be cleared twice.
9
2
Now repeat the "Search Method. "
and
do not work for your RCA TV.
CH +
CH -
Due to RCA design (1983- 1987), only the original
remote control will operate these functions.
Remote control does not turn on Sony or Sharp
TV/VCR Combo.
For power on, these products require programming
TV codes. For Sony, use TV code 0000 and VCR
code 0032. For Sharp, use TV code 0093 and VCR
code 0048.
Need additional information:
• Please visit : www.oneforall.com
ENTER
9
on the remote
SET
9
Hide quick links:
Advertisement
Table of Contents
