Advertisement
Lynx & QuickConnect Troubleshooting
BYPASS
CA/ALARM CANCELED
CC/MODEM COMM
CHIME
d1 (DL)
EA/EXIT ERROR
FAULT [zone #]
FAULT 103/LNG RNG
TRBL
FC/COMM FAIL
FIRE
https://alpha.adt.com/help/206[11/13/2018 8:20:40 PM]
For more information about Bypass Protection Zones, please refer to the
Ademco Lynx User Guide
The alarm has been canceled after sounding during the exit delay. Clear this
message by entering [security code] + [OFF], [security code] + [OFF]. This is an
informational message.
The panel is communicating with the Central Station computer and will not
operate while on the line. The message will clear in 1-2 minutes. This is an
informational message.
This code appears when the CHIME feature is activated. This is an
informational message.To turn Chime on/off, press [FUNCTION] + [CHIME].
The system is either powering up after a recent power outage or is in Standby
Mode. This informational message should clear in 2-3 minutes.
An Exit Alarm has occurred. This alarm is caused by a zone being open at the
end of the exit delay time. It can also be caused when a fault occurs in any
zone within two minutes after an exit delay. Reset the keypad by pressing
[security code] + [OFF], [security code] + [OFF].
A problem exists with the displayed zone. There will be rapid beeping from
the keypad. Press any key on the keypad to silence the beeping. Refer to the
Peripheral Device Troubleshooting
corrected, the FAULT display will disappear from the keypad screen.
This message indicates that there is a problem with the cell unit, a case
tamper or a loss of network registration. Refer to the
Troubleshooting
page.
The system has failed to communicate with the Customer Monitoring Centers.
Refer to the
Communication Failure Troubleshooting
A fire alarm or fire zone fault is present. The zone that is experiencing the
fault will display.
For a fire alarm, the keypad and siren will sound:
3 pulses – pause – 3 pulses – pause – 3 pulses - pause...
Reset the keypad by pressing [security code] + [OFF], [security code] + [OFF].
If the keypad does not clear, the smoke detector may still be detecting smoke
or heat. Remove the source of the smoke or heat if it can be done safely. It
may be necessary to fan the detector for 30 seconds to clear the smoke from
or the
Safewatch QuickConnect User
page. Once the problem has been
Guide.
Communication Failure
page.
Advertisement
