Table of Contents
Advertisement
7. CONTROLS
CONTROL
BEZEL
ROLL-OUT
SWITCH
GAS
VALVE
Figure 27. Location of Controls (View One)
DRAIN
PLUG IN
REAR
HEADER
Figure 28. Location of Controls (View Two)
Control Panel Removal
1. Remove screw from front door. Set aside door for
serviceability.
2. Remove four (4) screws from sides of control panel.
3. Rotate control panel down until panel stops. Do not
force.
TEMP SENSOR
HL1 - HIGH LIMIT
HL2 - HIGH LIMIT
T&P
GAUGE
FLOW
SWITCH
PRV
PROTEK
SHIELD
ASSY
F10640-6
PILOT
F10640-3
NOTE: Caution must be used to not damage controls
or wiring.
Figure 29. Knurled Screw Location
Control Adjustments
The pool heater touch-pad, located on the upper front
panel of the heater, allows the user to select either POOL
or SPA operation, and to adjust the setpoint temperature.
The LCD display window indicates the mode (OFF, SPA,
POOL) and the actual water temperature. A manual power
switch provided below the touch-pad turns the control
power ON or OFF. See Figure 30.
TEMP ADJUST BUTTONS
LCD DISPLAY
Figure 30. Control Adjustment
Mode Button
The MODE button is used to select POOL or SPA operation.
It also allows the user to turn the heater off electronically,
allowing the LCD to remain energized and to continue
showing the actual water temperature.
Temp Buttons
If the heater is in POOL or SPA mode, the desired water
temperature (SETPOINT) will be displayed and may be
adjusted using the UP or DOWN buttons.
KNURLED
SCREW
F10646-9
MODE BUTTON
TEMP
MODE
ON
OFF
23
Advertisement
Table of Contents
