Warranty Repairs - Speed Queen Alliance DR7003WG User Manual

Troubleshooting
Dryer Symptom
Dryer is noisy
Clothes are too wrinkled
Clothes have odor
Cycle advances too slowly
Er, ro on digital display
Items still wrinkled after the steam cycle.
Items are damp or wet after steam cycle.
Small amount of water on door or in the drum.
Small amount of water on the floor in front of the dry-
er.
Small amount of water on the floor behind the dryer.

Warranty Repairs

If something should occur with your washer or dryer that re-
quires service please use the service locator at www.speed-
queen.com.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Possible Cause/Solution
• Check dryer for foreign objects (nails, coins, bobby pins, metal,
plastic toys, etc.). Remove items from dryer.
• Make sure dryer is level. Uneven leveling can cause vibration.
• Normal operating sounds include the heat source going on and off
and the humming of air moving through the dryer and exhaust sys-
tem.
• Check heat setting. Overdrying can cause wrinkling.
• Check load size. Large loads may not tumble properly and may
cause wrinkling.
• On Auto-Sensing cycles, try using Steam Boost to release wrinkles.
• Check room for odors before drying clothes. Any odor (fried foods,
paint, varnish, cleaners, burning wood, etc.) will transfer to clothing
as the dryer draws air from the room.
• Ventilate room before drying clothes.
• When in an Auto-Sensing cycle, the time it takes depends on the
type and size of the load being dried. When clothing has more
moisture, the cycle takes longer than when the clothes are more
dry.
• The dryer's motor overload protector has cycled.
• The control can be cleared by pressing the Start/Pause button and
the dryer can be restarted by pressing the Start/Pause button
again.
• If this code is displayed again, remove the dryer from use and call
a service person.
• Do not overload the machine. Overloading the machine can cause
wrinkles to not be completely removed.
• Do not overload the machine. Overloading during the steam cycle
can cause the load to have wet spots at the end of the cycle.
• Do not use overly damp items. This may result in the load not dry-
ing completely.
• When using the steam options, it is normal for condensation to oc-
cur.
• Condensation may occur and drip from door when opened.
• Too small of a load may result in additional condensation on door.
Try adding more items to the load.
• Check the hose connections and tighten them if needed.
• Check that the rubber washer is intact. If not, install the rubber
washer.
We would like to point out items that would not be considered
a product failure and are not covered under warranty. If a serv-
ice technician is called for the items listed below you will be re-
sponsible for payment of the service call.
• Plugged or restricted venting
20 Part No. D518541ENR3