Wolf R482CF Use & Care Information Manual page 27

W O L F G A S R A N G E C A R E
C A R E R E C O M M E N D AT I O N S
C O M P O N E N T C A R E R E C O M M E N D A T I O N
Exterior Finish Do not use abrasive cleaners; they will permanently scratch the surface.
Bull-Nose Riser
Salt and some cooking liquids may pit and stain the surface. Always remove
Stainless steel
these spills immediately. Use a spray degreaser to remove fingerprints and
greasy spatters. Spray on a cloth and wipe surface. Buff dry immediately to
avoid streaking. For hard water stains, use white vinegar and water.
Exterior Cleaning: Use a soft, nonabrasive stainless steel cleaner like
Signature Polish (see side note) and apply with a soft lint-free cloth. To bring
out the natural luster, lightly wipe the surface with a water-dampened
microfiber cloth, followed with a dry microfiber cloth. All work should follow
the grain direction of the finish. Better results are obtained by keeping the
cloth in continuous contact with the metal.
Burner Base Allow burner base and cap to cool first. Wash in warm water and liquid
and Cap detergent. Rinse and dry.
Porcelain enamel
Spray degreasers and mild abrasive cleaners may be used.
(matte finish)
and brass
Drip Pan Caution! Do not use abrasive cleaners (e.g. Comet); they will perma-
Porcelain enamel nently scratch the surface.
(glossy finish
Salt and some cooking liquids may pit and stain the surface. Always remove
on steel)
these spills immediately. For general care, use a clean cloth or sponge; wipe
with warm water and a mild dish detergent. Rinse and dry immediately. Use
a spray degreaser to remove fingerprints and greasy spatters. Spray on a
cloth and wipe surface. Buff dry immediately to avoid streaking. For hard
water stains, use white vinegar and water.
Remove from gas range top and place on a flat surface near the sink.
Burner Grates
Porcelain-coated,
Nonabrasive cleaners to use include: Hot water and liquid detergent, paste of
cast iron
baking soda and water, plastic pad or sponge.
Spray degreasers and mild abrasive cleaners may be used.
Control Knobs Wipe with damp cloth and mild soap and water; rinse and dry. Never soak
Plastic or use abrasive cleaners; they will scratch the finish and remove the
(red or black)
markings.
Control Panel Use a spray degreaser to remove fingerprints and food soils. Spray first on a
Stainless steel cloth before wiping panel. Do not spray directly on panel around valve
stems.
Dimensions in parentheses are in
millimeters unless otherwise specified.
S I G N A T U R E
P O L I S H
Signature Polish
is available from
Signature Limited
Laboratory,
P. O. Box 13436,
Dayton, Ohio
45413-0436, or
call 877-376-5474
(toll free).
27