Note:
- If the indicator does not light green, check the connection.
- If more than 20 minutes have passed since the camera was turned on,
the camera cannot be set up from the Setup Program. In this situation,
disconnect the AC cord from the outlet, and reconnect it again.
- The Setup Program may not list any cameras due to your firewall or
antivirus software settings on your PC. If you cannot disable your
firewall or antivirus software, you can set up the camera entering the
camera MAC address on the following window. The camera's MAC
address can be found on the label affixed to the back of each camera.
4. Click [Automatic Setup (Local Access Only)].
- For the first time installation or after pressing the FACTORY DEFAULT
RESET button, only [Automatic Setup (Local Access Only)] can be
selected. To set up the camera with Static or DHCP settings, after
performing the [Automatic Setup (Local Access Only)], run the Setup
Program again and select [Manual Setup].
19