Keypad Entry; Emergency Calls; Public Address (Pa); Horn Alert - Kenwood TK-7185E Instruction Manual

K E
EYPAD NTRY
Besides using the
entering the numbers using the microphone keypad.
• Refer to the dialing codes listed in the appendix, starting on page 25.
■ R
EDIALING
If a key has been programmed with Redial (default is the A key), you can
easily redial previously dialed call addresses.
Redial:
1 Press the key programmed as Redial.
2 Press the
3 Press the Call key or the PTT switch to initiate the call.
E C
MERGENCY ALLS
If your transceiver has been programmed with the Emergency function, you can
make emergency calls.
Note: Only the
Press and hold the key programmed as Emergency.
• Depending on the delay time programmed into your transceiver, the length of time you
must hold the Emergency key will vary.
P A (PA)
UBLIC DDRESS
If your transceiver is connected to an external PA speaker, you can use the
transceiver as a Public Address system.
1 Press the key programmed as Public Address.
• The icon appears on the display while the PA system is active.
2 Press the microphone PTT switch, then speak into the microphone.
• Press the
from the external speaker.
3 Press the Public Address key again to return to normal operation.
H A
ORN LERT
If your transceiver is connected to your vehicle horn or other external device, this
function can alert you of an incoming call when you are away from your vehicle.
Toggle Horn Alert ON and OFF by pressing the key programmed as Horn Alert.
• The icon appears on the display while Horn Alert is active.
14
and keys, you can enter dialing codes manually, by
and keys to select 1 of the 3 last dialed numbers.
key can be programmed with the Emergency function.
and keys (Volume Up / Volume Down) to adjust the audio output