Table of Contents
Advertisement
MPEG2-TS Setting
For configuring the MPEG2-TS setting.
[Setting Values: RRTP, UDP]
9 First Stream/Second Stream
For configuring the First Stream/Second Stream of
MPEG2-TS.
[Setting Values: on, Roff]
9 Destination Address
For configuring the IP address of the destination.
[Setting values: 192.0.2.1 (First stream), 192.0.2.2
(Second scream)]
9 Port
For setting the port of the live streaming
destination.
The default values are "6688" (First stream) and
"6690" (Second stream).
ZeroConfig
For allowing this camera to be detected
automatically by external devices (such as
switchers) connected to the same LAN.
Connection can be established via one link from
the menu of the external device.
Memo :
The Zero Config function is not equipped with
0
the function to change the settings of the
camera.
9 Announcement
For configuring the method of connection from an
external device during automatic detection of this
camera.
[Setting Values: Ron, off]
9 Hostname Prefix
Part of the host name can be changed. (Up to 8
characters)
The default value is "PZ510".
Memo :
The following setting values are common. Any
changes made to an item will cause the other items
to be changed at the same time.
[Network] B [ZeroConfig] B [Hostname Prefix]
0
[NDI Settings] B [NDI Settings] B [NDI Local
0
Device Name] W
[Information] B [Information] B [Device ID]
0
36
Network
NTP Settings
Enables display of time information acquired from
the NTP server on the streaming video.
9 NTP time sync
Configuring to "on" enables time information to be
acquired from the NTP server.
[Setting Values: on, Roff]
9 Time Zone
For setting the GMT time difference in units of 1
hour.
[Setting Values: GMT-11:00 to GMT
+13:00(RGMT-05:00 (U model)), (RGMT+00:00
(E model))]
9 Server address
For setting the address of the NTP server.
[Default Value: ntp.example.com]
9 Time interval(min)
For configuring the interval between time queries
to the NTP server to a value between 0 and 99999.
[Default Value: 1440]
9 Main time show, Sub time show
Configuring to "on" displays the NTP time
information on the streaming video.
[Setting Values: on, Roff]
Memo :
To display the NTP time information on the live
0
screen, configure [Encode Codec] of [First
Stream] or [Second Stream] to "H.264". If the
display is too small, decrease the [Resolution]
for [First Stream] or [Second Stream]
accordingly.
9 Position
For configuring the position for displaying the First
Stream time or Second Stream time.
Configure the display position with the top left
corner of the screen as [X0, Y0] and the bottom
right corner as [X100, Y100].
[Default Values: X0, Y0]
Advertisement
Table of Contents
