Network - JVC KY-PZ510NWU Instructions Manual

Network

For configuring network-related settings.
After configuring the items, press the [Submit＆
Reboot] or [Submit] button.
The settings will be applied when the camera is
next restarted.
SRT Settings
Configuring it to "on" and pressing the [Submit＆
Reboot] button starts SRT streaming after the
camera is restarted.
[Setting Values: Ron, off]
9 SRT Mode
For configuring the SRT connection mode.
[Setting values: Caller, RListener, Rendezvous]
9 SRT Server
For setting the address of the SRT server.
The default value is 192.0.2.1.
Memo :
This item can be configured when [SRT Mode]
0
is set to "Caller" or "Rendezvous".
9 SRT Port
For configuring the SRT port for use during live
streaming.
The default value is "4578".
9 SRT Encryption
For configuring SRT encryption.
[Setting values: RNone, AES-256, AES-192,
AES-128]
9 SRT Password
For configuring the SRT password.
You can enter up to 10 to 15 characters.
The default value is "1234567890".
9 SRT Bandwidth Overhead
Enter the SRT bandwidth overhead using an
integer between 5% and 100%.
The default value is "25%".
9 SRT Latency
Enter the amount of SRT latency using an integer
between 20 ms and 8000 ms.
The default value is "500ms".
9 SRT FEC
For configuring the FEC mode.
It enables recovery of data streaming packet loss
without retransmission.
[Setting values: 6x6, 8x8, 10x10, Roff]
9 SRT StreamId
For setting the registered stream ID of the live
distribution destination. It allows direct streaming
of multiple cameras on a single device.
* You can enter up to 50 characters.
Memo :
Input and change are possible only when [SRT
0
Mode] is configured to "Caller".
RTSP Settings
9 RTSP Port
For configuring the RTSP port.
The default value is "554".
9 RTSP Auth
Configuring to "on", the user name and password
are required to receive streaming.
[Setting Values: on, Roff]
RTMP(S) Settings
9 First Stream
For configuring the RTMP(S) First Stream video.
Configure the setting to "on" for streaming and
press the [Submit＆Reboot] button. RTMP(S)
streaming will start after the camera is restarted.
[Setting values: on, Roff]
Memo :
The settings in [Video]-[First Stream] will be
0
applied as the video settings.
9 Second Stream
For configuring the RTMP(S) Second Stream
video.
Configure the setting to "on" for streaming and
press the [Submit＆Reboot] button. RTMP(S)
streaming will start after the camera is restarted.
[Setting values: on, Roff]
Memo :
The settings in [Video]-[Second Stream] will be
0
applied as the video settings.
9 MRL
For configuring the streaming server address for
the RTMP(S) First Stream/Second Stream.
First Stream
[Default Value: rtmp://192.0.2.1/live/stream0]
Second Stream
[Default Value: rtmp://192.0.2.2/live/stream1]
35
Network