Kodak Truper 3210 Operator's Manual page 108

Error Code Status Message
— ***Warning***
The rollers need to be
replaced. Please replace
the rollers.
Please select Clear
Counter button after
replacing the rollers.
— *** Warning ***
Insufficient front light error
occurred.
The lamp and/or scanning
sensor need to be
replaced.
— *** Warning ***
Insufficient back light error
occurred.
The lamp and/or scanning
sensor need to be
replaced.
— *** Warning ***
The front reference plate
may need to be cleaned.
Please clean the front
reference plate.
— *** Warning ***
The back reference plate
may need to be cleaned.
Please clean the back
reference plate.
— Scanner is not connected.
www.kodak.com/go/docimaging
Possible Cause
Warning counter expired.
Rollers need to be replaced.
It is time to replace the lamp
and scanning sensor (front).
It is time to replace the lamp
and scanning sensor (back).
The front reference plate is
dirty.
The back reference plate is
dirty.
The scanner is not connected.
The scanner is not turned on.
The computer was turned on
before the scanner was ready.
Remedy
Replace the rollers. See
page 92. After replacing the
rollers, return to the User Utility
and click the Clear Counter
button for "After Replace Roller."
See page 104.
Replace the lamp and scanning
sensor (front) by contacting your
Authorized Service Provider.
Replace the lamp and scanning
sensor (back) by contacting your
Authorized Service Provider.
Clean the front reference plate.
See page 85.
Clean the back reference plate.
See page 85.
Connect the scanner to the
computer, turn on the scanner
and restart the computer.
Turn on the power to the
scanner and then restart the
computer.
Restart the computer.
108 of 144