Kodak EasyShare Photo Printer 500 User Manual page 54

Troubleshooting
USB device connector light
Light status
Light is off
Card slot light (SDIO/memory card behavior)
Light status
Light blinks green
Light is off
48
Cause
There is no device connected to
the USB device connector on the
printer.
The connection between the
printer and device is loose.
A device other than a compatible
Kodak card reader or PictBridge
compatible camera or device is
connected.
Cause
Slow blink: the internal card
reader is initializing or
communicating with the
printer.
Fast blink: there is a card or
communication error.
An SDIO/SD/MMC card is not
inserted or is improperly
inserted in the card slot.
Action/solution
None required.
Check the USB connections from the
device to the printer.
Disconnect the device. Connect a Kodak
8-in-1 card reader, or a PictBridge
compatible camera or device.
Action/solution
None required.
Remove the card and make sure the
card is not write protected or damaged.
Replace with a new card if necessary.
Reinsert the card.
None required.
www.kodak.com/go/support