Setting Up Internal Vlan Id And Multi-Cast Support For The Ports - Extreme Networks Summit WM User Manual

Configuring the Summit WM Controller
In the Domain Name box, type the name of the domain that you want the Altitude APs to use
for DNS Server's discovery.
In the Lease (seconds) default box, type the time period for which the IP address will be
allocated to the Altitude APs.
In the Lease (seconds) max box, type the maximum time period in seconds for which the IP
address will be allocated to the Altitude APs.
In the DNS box, type the DNS Server's IP address if you have the DNS Server.
In the WINS box, type the WINS Server's IP address if you have the WINS Server.
NOTE
You can type multiple entries in DNS and WINS text boxes. Each entry must be separate by a comma. These two
fields are not mandatory to be typed to enable the local DHCP feature.
10 To save your changes, click Save.
NOTE
When you deselect the DHCP checkbox, the DHCP fields disappear in the lower pane. When you again select the
DHCP box, all the DHCP fields are again populated and visible.

Setting up Internal VLAN ID and multi-cast support for the ports

You can configure Internal VLAN ID, and enable multicast support for any of the data ports.
To configure the Internal VLAN ID and enable multicast support:
1 From the main menu, click Wireless Controller Configuration. The Summit WM Controller
Configuration page is displayed.
2 In the left pane, click IP addresses. The Interfaces page is displayed.
3 Click the Global tab. The Global page is displayed.
42
Summit WM User Guide, Software Version 5.3