Card Features; Minimum System Requirements - Xilinx Alveo U200 Getting Started

Card Features

Features of the production Alveo U200/U250/U280 data center accelerator cards are listed in
the following table.
Table 1: Alveo U200/U250/U280 Features
Card Component
FPGA
DDR4
HBM
Configuration Options
PCIe
Network Interface
I2C Bus
Status LEDs
Power Management
Electrical Design Power
Flash Memory
UART
Configuration
Notes:
1. Vitis unified software platform based applications are only designed to run with electrical design power at 215W.

Minimum System Requirements

The minimum system requirements for running the Alveo™ U200/U250/U280 Data Center
accelerator cards are listed in the following table.
UG1301 (v1.8) February 5, 2021
Getting Started with Alveo Accelerator Cards
U200
UltraScale+
XCU200-2FSGD2104E
64 gigabyte (GB)
4x DDR4 16 GB
2400 mega-transfers per second (MT/s), on 64-bit ECC DIMM
–
1 gigabit (Gb) Quad Serial Peripheral Interface (SPI) flash memory
Micro-USB JTAG configuration port
16-lane PCI Express
PCIe Integrated Endpoint block connectivity
Gen1, 2, or 3 up to x16
2x QSFP28
✓
✓
Power management with system management bus (SMBus) voltage, current, and
temperature monitoring
65W PCIe slot functional with PCIe slot power only
140W PCIe slot functional with 110A max V
power cable connected
215W PCIe slot functional with 160A max V
1
power cable connected
Onboard reprogrammable flash configuration memory
UART access through the USB port
UltraScale+ device configurable over USB/JTAG and Quad SPI configuration flash memory
U250
UltraScale+
XCU250-2LFIGD2104E
–
2x QSFP28
✓
✓
current PCIe slot power and 6-pin PCIe AUX
CCINT
current PCIe slot power and 8-pin PCIe AUX
CCINT
Send Feedback
Chapter 1: Introduction
U280
UltraScale+
XCU280-L2FSVH2892E
32 gigabyte (GB)
2x DDR4 16 GB
8 GB, 32-pseudo channels
Gen1, 2, or 3 up to x16
Gen4 x8
2x QSFP28
✓
✓
www.xilinx.com
8