ABB M4M 30 User Manual page 40

40 M4M 30 NETWORK ANALYZER USER MANUAL
• Channels
It is possible to configure each channel to one of the following parameters, allowing to store one
parameter in each channel. Up to 25 parameters can be selected and stored. Default parameters are
already configured and defined in the M4M for each channel, see details below.
Channels parameters
Active Power Imp. Tot. (CH1 default value)
Active Power Imp. L1 (CH2 default value)
Active Power Imp. L2 (CH3 default value)
Active Power Imp. L3 (CH4 default value)
Reactive Power Imp. Tot. (CH5 default value)
Reactive Power Imp. L1 (CH6 default value)
Reactive Power Imp. L2 (CH7 default value)
Reactive Power Imp. L3 (CH8 default value)
Apparent Power Imp. Tot. (CH9 default value)
Apparent Power Imp. L1 (CH10 default value)
Apparent Power Imp. L2 (CH11 default value)
Apparent Power Imp. L3 (CH12 default value)
Active Power Exp. Tot.
Active Power Exp. L1
Active Power Exp. L2
Active Power Exp. L3
Reactive Power Exp. Tot.
Reactive Power Exp. L1
Reactive Power Exp. L2
Reactive Power Exp. L3
Apparent Power Exp. Tot.
Apparent Power Exp. L1
Apparent Power Exp. L2
Apparent Power Exp. L3
→ → Historicals → Load profile → Channels
Channels parameters
Voltage L1 (CH13 default value)
Voltage L2 (CH14 default value)
Voltage L3 (CH15 default value)
Voltage L1-L2 (CH16 default value)
Voltage L2-L3 (CH17 default value)
Voltage L1-L3 (CH18 default value)
Current L1 (CH19 default value)
Current L2 (CH20 default value)
Current L3 (CH21 default value)
Current N. (CH22 default value)
THD Voltage L1
THD Voltage L2
THD Voltage L3
THD Voltage L1-L2
THD Voltage L2-L3
THD Voltage L3-L1
THD Current L1 (CH23 default value)
THD Current L2 (CH24 default value)
THD Current L3 (CH25 default value)
THD Current N
Power Factor Tot.
Power Factor L1
Power Factor L2
Power Factor L3