Complete Installation; Assistance - KitchenAid Architect Series KBMS1454R Installation Instructions Manual

NOTES:
The side bracket must slide over the top of the Z-bracket.
The vertical flap of side bracket must rest against Z-bracket,
with screw holes aligned, as shown.
A
A. Side bracket
B. 1/2" T-10 screw
C. Z-bracket
9. Fasten side brackets to Z-brackets using two 1/2" T-10
screws.
10. Open microwave oven door.
11. Position the tabular portion of the side trim panel behind the
door facing frame, then firmly push the outside edge of the
trim behind the Z-bracket, as shown.
Exploded View of Panel Placement
A B
A. Door facing frame
B. Z-bracket
C. Side trim panel
8205303/4619-694-50851
© 2005.
All rights reserved.
B C
C
12. Attach the side trim panel to the door facing frame using two
1" T-10 screws.
A
B
C
A. Door facing frame
B. Trim panel
C. 1" T-10 screws (4)
13. Repeat steps 11 and 12 on other side.

Complete Installation

1. Install the turntable in the microwave oven.
2. Check the operation of microwave oven by placing 1 cup
(250 mL) of water on the turntable and programming cook
time of 1 minute at 100% power.
Installation is now complete.
Save these Installation Instructions for future use.

ASSISTANCE

If the microwave oven does not operate:
Check that a circuit breaker has not tripped, or a house fuse
blown.
Check that the power supply cord is plugged into a grounded
3-prong outlet.
See the Use and Care Guide for troubleshooting information.
If you need assistance:
Call your authorized dealer or service center. When you call, you
will need the microwave oven model number and serial number.
Both numbers can be found on the model and serial number
plate, which is located behind the microwave oven door on the
front frame of the microwave oven.
1/05
Printed in Sweden