Installation Requirements; Tools And Parts; Location Requirements - KitchenAid Architect Series KBMS1454R Installation Instructions Manual

Tools and Parts

Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Measuring tape
Pencil
Torx T-10 screwdriver
Parts Supplied
All of the following parts are provided, but not all parts will be
used. The cutout opening size will determine which parts you will
use. See chart below parts list to see which parts are used for
each installation.
C
E
G
A. Z-brackets (2)
B. 1/2" T-10 screws (6)
C. Narrow side brackets, marked LEFT 27" and RIGHT 27" (2)
D. Narrow side trim panels (2)
E. Wide side brackets, marked LEFT 30" and RIGHT 30" (2)
F. Wide side trim panels (2)
G. 1" T-10 screws (4)
INSTALLATION
24" (61.0 cm) installation
27" (68.6 cm) installation
30" (76.2 cm) installation
2

INSTALLATION REQUIREMENTS

Electric drill
5/64" (2 mm) drill bit
A
B
D
F
PARTS USED
G
A, B, C, D, G
A, B, E, F, G

Location Requirements

The microwave oven may be located in a cabinet, and/or above a
built-in oven, or below the counter and/or below a non-vented
cooktop. Check the opening where the microwave oven will be
installed. The location must provide:
Wood cabinetry.
Cutout opening that is plumb and square. For proper
installation, the bottom corners must be cut at right angles.
See "Minimum Cutout Dimensions" section.
Cutout floor that is solid, level and flush with bottom of
cabinet cutout.
Support for weight of at least 150 lbs (68 kg), which includes
microwave oven and items placed inside.
Grounded electrical outlet. See "Electrical Requirements"
section.
Minimum installation clearances for installation location. See
"Minimum Dimensions" section.
We recommend:
Complete enclosure around the recessed portion of the
microwave oven.