Multi-Room And Ir Receiver Setup; 12 Volt Trigger Setup - Pioneer Elite VSX-80TXV-S Operating Instructions Manual

Other Settings
• OFF – No conversion between video formats.
3 When you're finished, press RETURN .
You return to the Other Setup menu.

Multi-Room and IR receiver setup

• Default setting: Variable / Setting 1
If you've made multi-room connections (see Multi-room
listening on page 46) you may need to specify your
volume setting. Also use this menu to specify your IR
receiver type (if necessary).
1 Select 'Multi Room Setup' from the Other Setup
menu.
6. Other Setup
a.DRC Setup
b.Dual Mono Setup
c.LFE ATT Setup
d.SR + Setup
e.Video Conv. Setup
f. Multi Room Setup
g.12V Trigger Setup
2 Select the volume level setting.
• Variable – Use this setting if you've connected a
power amplifier in the sub room (this receiver is
simply being used as a pre-amp) and you will be
using this receiver's controls to adjust the volume.
• Fixed – Use this setting if you've connected a fully
integrated amplifier (such as another Pioneer VSX
receiver) in the sub room and want to use that
receiver's volume controls.
With the Fixed setting, the source is sent from this
receiver at maximum volume, so make sure the volume is
quite low in the sub room at first and then experiment to
find the correct level.
3 Select the type of IR receiver you're using.
• Setting 1 – Use this setting for all (other) IR
2
receivers.
• Setting 2 – Use this setting if the IR receiver you're
using doesn't seem to work after selecting Setting 1.
4 When you're finished, press RETURN .
You return to the Other Setup menu.
Note
1 If you selected MR & S in the Surround back speaker setting on page 33, you won't be able to change the volume level.
2 Some IR receivers may not work with this receiver. Check with your audio dealer for more information.
6f. Multi Room Setup
Volume Level
Variable
IR Setting
[Setting 1]
Be c are fu l o f lo ud
vo lum e wh en " F IXE D "
is selec ted .
:Finish
1

12 Volt Trigger setup

• Default setting: OFF (all components)
After connecting a component the 12 volt trigger (see
Switching components on and off using the 12 volt trigger
on page 48), it switches on automatically when you select
an input function set to switch the trigger on. Specify
which input functions switch on the trigger below.
1 Select '12V Trigger Setup' from the Other Setup
menu.
6. Other Setup
a.DRC Setup
b.Dual Mono Setup
c.LFE ATT Setup
d.SR + Setup
e.Video Conv. Setup
f. Multi Room Setup
g.12V Trigger Setup
2 Select an input function and choose the setting
that you want.
This should be the input function, that when selected,
switches on the 12 volt trigger.
6g. 12V Trigger Setup
DVD / LD
TV / SAT
DVR1
DVR2
VIDEO
TUNER
CD-R
CD
XM
• OFF – 12 volt trigger is not activated for the selected
component.
• ON – 12 volt trigger is activated for the selected
component.
3 Repeat for as many input functions as you would
like to set.
4 When you're finished, press RETURN .
You return to the Other Setup menu.
6g. 12V Trigger Setup
DVD / LD [ OFF ]
TV / SAT [ OFF ]
DVR1 [ OFF ]
DVR2 [ OFF ]
VIDEO [ OFF ]
TUNER [ OFF ]
CD-R [ OFF ]
CD [ OFF ]
XM [ OFF ]
:Finish
[ ON ]
[ OFF ]
[ OFF ]
[ OFF ]
[ OFF ]
[ OFF ]
[ OFF ]
[ OFF ]
[ OFF ]
:Finish
09
53
En