Motorola M68EM05A24 User Manual page 10

1
Table 1-1. Parts required to form a target cable assembly for A24EM
Cable No.
M68CBL05B
MOTOROLA
1-6
To connect your A24EM to your target system via a separately pur-
chased, target cable and head assembly, follow the instructions below.
Figure 1-4 is a generic representation of a Motorola supplied target
cable assembly, which consists of a flexible cable and a SDIP target
head. Emulation of a SDIP device is achieved by fitting the SDIP target
head into the MCU socket of the target system. Table 1-1 shows the tar-
get cable and head part numbers required to form a 56-pin SDIP target
cable assembly for the A24EM.
Target Head No.
M68TB05A24B56 56-pin SDIP cable assembly
To use a SDIP target cable, connect the large cable terminator of
M68CLB05B to M68TB05A24B56. They should be connected in such
a way that the arrow marked on the target head is pointing to the target
cable. Next, connect the small cable terminator to the A24EM target
connectors P7 and P8. The connector at the far end of the cable should
be connected to P7 and the other to P8. Plug the target head into the
MCU socket of your target system.
If you install the A24EM in the MMDS05 station module, run the target
cable through the slit in the station module enclosure.
Notes
HC05A24EM USER'S MANUAL