JVC RD-E761 Instruction Manual page 6

To install the batteries
Lift off the battery compartment cover from the rear of the remote control. Insert 2 x 1,5V AAA
size batteries in accordance with the diagram in the battery compartment. Take care to observe
the correct polarity.
Remote control operation
To operate the device with the remote control, point the remote handset at the remote sensor
on the front panel and press the appropriate button on the remote handset.
The remote works best within a range of 6 ~ 7 meters from the front panel and on an angle of
30 degrees. Bright sunlight or room light conditions can interfere with the remote control. If the
remote operation is unsatisfactory or stops working entirely, first try replacing the remote
batteries, then try reducing the room lighting conditions.
GETTING STARTED
CONNECTION AND PREPARATION
Power connection
Connect the mains cable to the AC INPUT socket of the device and then into a mains socket.
Warning: Ensure that the power supply voltage corresponds to the voltage printed on the back of the
device.
LINE IN connection
You can use the LINE IN to play any music from your phone or tablet. Connect the audio cable
(included) to the LINE IN jack and the other end connects to the AUDIO OUT jack of your
external device. Adjust the volume to your desired level. Press PLAY of the external audio
source (eg. MP3 player) to start playback.
L/R AUDIO output connection
You can use the L/R AUDIO output to listen to music from this device on another external audio
device. Use a suitable cable (not included) for the connection.
NOTE: L/R AUDIO output is active in CD and USB modes only.
GENERAL FUNCTIONS
Power on/off
Press the /I button on the device or press the
device. Switch off to the standby mode with the same button.
Mode selection
Press the FUNCTION button on the device or the remote control to select
CD (USB)/FM/LINE IN/BT mode.
NOTE: You can use the BLUETOOTH button on the device to select the Bluetooth mode. .
Volume
Press the V+/- buttons on the device or the remote control to adjust the volume. If you wish to
turn the sound off, press the
the V+/- buttons on the device or the remote control to resume normal listening.
Bass/Treble level
Press the BASS +/- buttons on the remote control to adjust the bass level.
Press the TREBLE +/- buttons on the remote control to adjust the treble level.
NOTE: You can use the TONE button on the device to set the Bass/Treble level.
button on the remote control to switch on the
button on the remote control. Press the
EN
button again or press