Related Manuals for Neilsen CT2279
Summary of Contents for Neilsen CT2279
- Page 1 2" AIR DIE GRINDER CT2279 Ref no. XX822 ORIGINAL INSTRUCTIONS Cannon Tools Limited Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. SAVE THESE INSTRUCTIONS AND PRECAUTIONS. READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.
-
Page 2: Ec Declaration Of Conformity
EC DECLARATION OF CONFORMITY We CANNON TOOLS LTD 20 Station road, Rowley Regis, West Midlands,B65 0JU.U.K. Declare that the following machine complies with the appropriate basic safety and health requirements of the EC Directive based on its design and type, as brought into circulation by us. - Page 3 1.SAFETY INSTRUCTIONS WARNING– When using tools, basic precautions should always be followed, including the following: General To reduce the risks of electric shock, fire, and injury to persons, read all the instructions before using the tool. Work area a. Keep the work area clean and well lighted. Cluttered benches and dark areas increase the risks of electric shock, fire, and injury to persons.
- Page 4 high intensity noise is able to cause hearing loss. i. Risk of Electric Shock. This Air Angle Die Grinder is not provided with an insulated gripping surface. Contact with a ″live″ wire will also make exposed metal parts of the tool ″live″ and shock the operator. j.
- Page 5 c. Use only the lubricants supplied with the tool or specified by the manufacturer. Air source a. Never connect to an air source that is capable of exceeding 200 psi. Over pressurizing the tool may cause bursting, abnormal operation, breakage of the tool or serious injury to persons.
-
Page 6: Specifications
SPECIFICATIONS Operating pressure: 6.3 Bar(90Psi) Free speed: 20000/min Air consumption: 4cfm Collet size: 1/4"(6mm) Air inlet: 1/4" COMPONENTS AND CONTROLS Throttle Air inlet Safety Lock Collet cap Regulator knob Spindle Collet INITIAL TOOL SET UP Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product. - Page 7 1. Incorporate an in-line oiler, shut-off valve, regulator with pressure gauge, and filter for best service, as shown in the diagram above. An in-line shut off valve is an important safety device because it controls the air supply even if the air hose is ruptured. Note: If an automatic oiler system is not used, add a few drops of Pneumatic Tool Oil to the airline connection before operation.
- Page 8 after the air supply is disconnected. Note: Air flow, and therefore Air Angle Die Grinder performance, can be hindered by undersized air supply components. 3. The air hose must be long enough to reach the work area with enough extra length to allow free movement while working. 4.
- Page 9 accessory must be rated to at least the maximum speed of the Die Grinder. 3. Use the Wrench to hold the Spindle in place, while tightening the Collet Cap . WARNING! Do not use with cutoff wheels, saws or any attachment that requires safety guard.
-
Page 10: Maintenance
or with the compressor’s air regulator. If the tool requires more force to accomplish the task, verify that the tool receives sufficient, unobstructed airflow (CFM). Then either: a. Turn off and disconnect the tool, adjust the Regulator Knob, then resume usage. - Page 12 CANNON TOOLS LTD Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K. Made in China...