Related Manuals for Neilsen CT3096
Summary of Contents for Neilsen CT3096
- Page 1 BENCH GRINDER 150W CT3096 Ref no.MD3215M INSTRUCTION MANUAL Please keep this instruction manual for future reference...
-
Page 2: Ec Declaration Of Conformity
Declare that the design and construction of the following machine, in the form supplied by us, comply with the requirements of the appropriate EC directives. Product description: BENCH GRINDER 150W Model: CT3096 ●EC-Machinery Directive 2006/42/EC ●EC-Low Voltage Directive 2006/95/EC CANNON TOOLS LTD... -
Page 3: Important Safety Instuctions
IMPORTANT SAFETY INSTUCTIONS: WARNING! When using electric tools, the following safety precautions should always be followed to reduce the risk of electric shock, personal injury and fire. Read all these instructions carefully before using the tool, and save for future reference or new users. - Page 4 Inspect the tool cable before use. Inspect the tool for any damage, cracks or missing parts. If in any doubt do not use and consult a qualified electrician. Keep the handle dry and free from oil and grease. Avoid Unintentional Starting Ensure the on/off switch is OFF before plugging into the mains.
- Page 5 produce a clear sound. If not , the wheel is damaged and must not be used. ♦ Regularly check a grinding or honing wheel for alignment. If the wheel is running out centre of out of balance, it must be replaced. ♦...
-
Page 6: Product Specification
PRODUCT SPECIFICATION: Model CT3096 Input Voltage 230V /50Hz Rated Power 150 W No load Speed 2950rpm Grinding wheel diameter 150mm Changing the grinding or honing wheel (Fig. A) To renew or change the grinding/honing wheels, follow these series of steps: (a) Switch off the unit and disconnected from the mains supply;... - Page 7 Do not use a damaged wheel. Mounting the spark guard(Fig. B & Fig. C) The spark guard offers additional protection from sparks and should be used whenever possible. A spark guard is supplied for each wheel. ♦ Fit the transparent screen to the spark guard by inserting a bolt into the creen and the guard and placing a washer and nut onto the bolt, tighten the nut(Fig.
- Page 8 Fig. C Adjusting the worpiece support(Fig. D) The workpiece support can be set according to the workpiece and the desired grinding angle. ♦ Slacken the nut holding the support. ♦ Set the support to the desired position and angle, making sure that the support is as close to the wheel as possible.
- Page 9 Instructions for use Always observe the safety instructions and applicable regulations. Always wear safety goggles when grinding dry. Switching on and off. ♦ Switching on:set the on/off switch to position 1. ♦ Switching off:set the on/off switch to position 0. Using the grinding wheel ♦...
- Page 10 CANNON TOOLS LTD Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K. Made in China...