Assembly - Breville AquaStation Chilled + Hot Instruction Book

Assembly

BEFORE FIRST USE
• Remove and safely discard any packaging
material or promotional labels attached to
your unit and filter. Check for any missing or
damaged parts as per the components list.
NOTE
As an important part of our quality control
process, your unit has been individually tested.
As a result, you may notice a small amount of
condensation or water droplets on the inside
of the water tank. There is no need for concern.
Please remove and discard the protective red
silicone rubber cap from the spout before use.
• Remove the Activ360™ 4-Stage filter from the
water tank and set aside.
• Do not wash the filter or insert into the
water tank until 'Flushing the Breville
AquaStation' and 'Preparing the Activ360
Filter' instructions are completed as found in
this book.
• Place the unit on a dry, flat level surface.
• Wash the water tank lid, water tank in warm
soapy water with a soft, non-abrasive cloth.
Rinse and dry thoroughly with a clean, soft,
lint-free cloth before returning to the unit.
• Assemble the water tank back onto the power
base.
• Plug the power plug into a 230/240V power
outlet and turn on the power outlet.
IMPORTANT
When moving the unit always lift from the base
using two hands and set down gently on a flat
and level surface.
14
FLUSHING THE BREVILLE
AQUASTATION
It is important to flush and rinse the dispensing
system before using the unit for the first time.
Before first use, it is recommended to carry out
the below steps without the Activ360™ Water
Filter in place.
1. Fit only the water tank into place with the
lid removed.
2. Fill the tank with cold tap water to the MAX
level. Never fill past the MAX level.
3. Place a 1L container under the dispensing
spout.
4. Press the START/STOP button once to
start dispensing ambient water until the
container is full, then press the START/
STOP button once again to stop dispensing.
Discard the collected water.
5. Repeat steps 3-5 until all the water in the
tank has been dispensed. Water dispensing
will stop dispensing when the water level is
too low or automatically after 60 seconds.
6. Proceed to the next step, 'Preparing the
Activ360™ Filter'.
PREPARING THE ACTIV360™ FILTER
Flushing the filter is required every time you
insert a new filter cartridge.
FILTER RESET
90d
Filter Reset will flash continuously on the
screen to notify after 90 days or 200L of water
MAX
filtered as an alert that it is time to replace the
filter cartridge.
MIN
NEW FILTER
10m
SHAKE FILTER