Miele DAS 4920 Installation Manual

Installation
Before installation

Before installation, it is important
to read the information given on the
following pages as well as the
"Warning and Safety instructions" at
the beginning of this booklet.
Installation recommendations
- To achieve optimum vapour
extraction, the cooker hood must be
positioned centrally over the hob, not
to the side.
- The hob should be no wider than the
cooker hood, and if possible, it
should be narrower.
- The installation area must be easily
accessible. The cooker hood should
be easily accessible and easy to
dismantle in the event that service is
required. This should be taken into
consideration when planning the
position of cupboards, shelves,
ceilings or features in the vicinity of
the cooker hood.
Installation materials
1 vent connection
for exhaust ducting  150 mm.
12062340-01
1 non-return flap
for fitting into the exhaust socket on
the motor unit (not needed for
recirculation mode). Depending on the
model, the non-return flap may already
be fitted.
4 mounting plates
for installation in a 600 mm wide
cabinet
2 brackets
for installation in a 900 mm wide
cabinet (only for 900 mm wide
appliances)
2 spring clips
for installation in a 900 mm wide
cabinet (only for 900 mm wide
appliances)
1 spacer strip
for concealing the gap between the
rear of the appliance and the wall