Table of Contents
Advertisement
Precautions
•
Always handle the unit with care to avoid damaging the LCD display panel. Damage caused by
physical shocks is not covered by the product warranty.
•
Avoid getting fingerprints on the screen. To clean the screen, wipe it with a clean, soft and dry towel,
being careful not to damage the LCD display panel.
•
To reduce the risk of fire or electric shock, do not expose the LCD to rain or moisture.
•
Do not connect power to the video input/output ports. It will cause a malfunction.
•
Only use the approved battery charger included in the package – a fire may be caused if a non
unapproved charger is used (if the red LED flickers during recharging, request after sales service).
•
The built-in Li-Polymer battery (11.1V / 2200mA) has a six month warranty - effective from the
purchase date. Do not use any another type of battery on this portable monitor as it may cause a fire
or explosion.
•
The battery could be damaged if a short circuit is present at the connecting port, or if the polarity of the
power cable is reversed.
•
When supplying power to the camera via the test monitor, always use the enclosed power harness
(DC Jack).
•
When supplying power, connect the power cable to the camera and then apply power. Otherwise, a
short circuit might be induced which automatically switches the unit off to protect the battery. If a short
is produced, turn the monitor off, remove and re-insert the power harness (DC Jack). Then turn the
unit on again.
•
Keep the unit inside the carry bag to protect the LCD screen from scratches.
•
Do not put the monitor on, or near, anything electrically conductive or expose the unit to rain or
moisture.
•
Immediately switch the product off if it emits smoke, makes an abnormal noise or emits strange
odours.
•
If the unit is not working properly, please contact your distributor. Please do not disassemble the unit
yourself as it will invalidate the warranty.
Hybrid Portable Test Monitor
3
Advertisement
Table of Contents
