DSC neo Power Series Installation Manual page 19

Trouble Trouble
indication Indicator Digit
Yellow LED
08
– 8 Flashes
Yellow LED
09
- 9 Flashes
Yellow LED
– 12 0C
Flashes
All LEDs
flashing N/A
together
Red and
Yellow
LEDs N/A
flashing
together
Only Green
LEDs N/A
flashing
Green LEDs
N/A
alternating
Possible
Causes
with the access point name provided by the cellular provider.
If Common Mode is used, and only one path is initialized while
l
the other path is not successful, generate a manual test
transmission over both paths or power cycle the communicator
to recover the 'Receiver Not Available' trouble.
Receiver
This trouble is indicated when supervision is enabled and the
l
Supervision
unit is not able to successfully communicate with the receiver.
If this trouble persists, contact the central station.
Trouble
l
The unit has exhausted all communications attempts to all
l
programmed receivers for events generated by the
FTC Trouble
communicator.
Restart the system, if trouble persists, contact the dealer.
l
This indication appears when section [021] system account
l
Module
code or sections [101], [111], [201], and [211] receiver account
Configuration
code have not been programmed. Ensure that a valid account
Trouble
code has been entered in these sections.
Boot Loader Disconnect power, then reconnect power to the communicator
l
module.
Failed
The unit is still initializing, please wait while the unit gets its
l
Initialization
programming and establishes a connection to all
programmed receivers.
Sequence
NOTE: This process may take several minutes to complete.
Hardware The hardware default jumper is installed and must be
l
removed. See Figure 3.
Default Jumper
Radio Reset or
If this status persists and the yellow LED shows 5 flashes,
l
Radio
confirm that the SIM card is active.
Initialization
19
Trouble Possible Solution