Setting The Vcr's Clock - Panasonic NV-FJ603EL-K Service Manual

Setting the VCR's Clock

Usually, the VCR's Auto Setup function automatically adjusts
the clock to the correct time.
Under some reception conditions, however, the VCR cannot
set the clock automatically.
In this case, follow the operation steps below to manually set
the clock.
To Manually Adjust the Clock
Press the MENU button S to display the Main menu on
1
the TV screen.
2 Press the Cursor buttons (34)
P to select "Clock setting" then
press the OK button R.
≥ The Clock setting menu
appears on the TV.
3 Confirm that "Automatic" is set to "OFF", and then press
the OK button R.
4 Use the Cursor buttons
(3421) P to set the date and
time.
≥ Instead of the Cursor buttons
(3421) P, you can also use
the numeric buttons 2 to set the
date and time.
5 Press the OK button R to conclude the setting.
6 Press the EXIT button Q to exit the On Screen Display.
To Activate the Automatic Time Correction
Function
If a TV station transmits a signal for time setting, performing
the operation steps below activates the Automatic time
correction function and the time is corrected automatically.
1 Press the MENU button S to display the Main menu on
the TV screen.
2 Press the Cursor buttons (34) P to select "Clock
setting" then press the OK button R.
≥ The Clock setting menu
VCR
Clock setting
3 Use the Cursor buttons
Automatic : OFF
(34) P to set "Automatic"
Time : 20:30:24
: 16.10.05
Date to "ON".
4 Press the OK button R to conclude the setting.
≥ Under adverse reception conditions, etc., the
VCR
5 Press the EXIT button Q to exit the On Screen Display.
Clock setting
Automatic : OFF
Time : 20:30:24
: 16.10.05
Date
Hints:
≥ If "Automatic" is set to "ON" when you open the Clock
screen, do not set it to "OFF", otherwise, the automatic time
correcting function is deactivated.
≥ The built-in clock employs the 24-hour system.
≥ In case of a power failure, an automatic back-up system
automatically maintains the operation of the clock for at
least 60 minutes.
≥ When "Automatic" on the Clock setting menu is set to "ON",
the automatic time correction function checks and if
necessary adjusts the time several times every day.
The automatic time correction function only works when
the VCR is switched off; it does not work in the timer
recording standby mode.
≥ If "Automatic" is set to "OFF" and "Power save" to "ON" (see
page 27), the time may not be maintained correctly. In this
case, manually adjust the clock.
≥ If "Automatic" is set to "ON" and "Power save" to "ON", the
Automatic time correction function does not work while the
VCR is turned off. However, as soon as it is turned on, the
Automatic time correction function is activated and the
clock is set correctly.
appears on the TV.
Automatic time correction function may not work. In
this case, the indication for "Automatic" is
automatically reset to "OFF".
If the reception conditions improve later on, it may be
possible to activate this function.
VCR
Clock setting
: ON
Automatic
Time : 20:30:24
Date : 16.10.05
25