Pg Shifter Adjustment / (Automatic) - Panasonic NV-FJ603EL-K Service Manual

Fig.E1
CONDITION : / BURST
SIGNAL OFF / 75 ohm
TERMINATED

3.3.4. PG SHIFTER ADJUSTMENT / (AUTOMATIC)

PROCEDURES
Press the FF and EJECT
buttons simultaneously for 3
seconds.
Press the FF and EJECT
buttons simultaneously twice.
Press the EJECT key for 3
seconds.
Press the CH UP key once.
Insert the Alignment Tape.
(PAL: VFJ81215H3F)
This adjustment is
automatically started. (During
the adjustment, the picture will
be appeared on the monitor.)
When this Adjustment is terminated, the following
operation will be activated.
-
Adjustment completed: The tape will be ejected.
-
Adjustment incompleted: "F2*" is indicated on the FIP.Check the Servo/
System Control circuit and Cylinder Unit.
To release Service Mode, press EJECT key and
key Simultaneously 6 times until the FIP becomes
normal indication.
Fig.E2
FIP Display
Fig. E3
20