Gasket - Hussmann Excel D5XEE Joining Instructions

D5XEE & D5XELE to D5X Lineup
Joining Instructions
REMOVE ITEMS FROM
2
/
PARENT CASES
GASKETS
Remove shelves (if installed),
display racks, honeycomb, pans,
front shelf supports and front air
grilles from the right end as shown
in Figure 2A.
Remove the lower back panel first
by lifting up from its bottom edge
and out. Do not use sharp tools.
Lift the upper back panel up and
out. Remove factory installed nut
retainers along vertical frame of
parent cases, (if installed).
Apply 1 in. Gasket (Item 1) around
perimeter of parent cases as shown
in Figure 2B. Check that there are
no gaps between gasket and case.
Apply 1 5 / in. Gasket (Item 2) so
8
that one edge is on the metal case
frame and the parallel edge laps the
1 inch gasket. Check that there are
no gaps between case and gaskets.
IMPORTANT
• Do not stretch gasket,
especially around corners.
• Do not butt gaskets;
always overlap them as shown.
• Remove paper backing
after gasket has been applied.
• Perimeter gasket required by NSF.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM
APPLY
Remove Items from Parent Cases / Apply Gaskets
P/N 0508902_A
FIGURE 2A
First Gasket
1 in. Gasket
(24 mm)
Second Gasket
5
1 / in. Gasket
8
(41 mm)
FIGURE 2B
3