Kärcher G 2000 QT Operator's Manual page 13

TROUBLESHOOTING – continued
• Loose fittings.
- Tighten fittings.
• Missing/worn rubber washer.
- Insert new washer.
• Spray wand not properly attached.
- Insert the spray wand into the trigger
gun. Carefully press in against the
spring tension and twist into the
locked position.
• Broken o-ring or plastic insert.
- Call Kärcher customer service
hotline and order repair kit
• Pump is sucking air.
- Check that hoses and fittings are air
tight. Turn off machine and
purgepump by squeezing trigger gun
until a steady flow of water emerges
through the nozzle.
• Loose fittings.
- Check that all fittings are tight.
• Water seals are damaged or worn.
- Call service center.
• Thermal protection device is
activated.
- Thermal protection device will auto
reset.
• Oil seals are damaged or worn.
Call service center.
WARRANTY USA
WARRANTY CDN
Kärcher Customer Support USA
Kärcher Customer Service CDN
13