Procedure After Replacing The Microprocessor, Etc; Firmware Update Procedure; Updating By Usb - Marantz SR5009/U1B Service Manual

PROCEDURE AFTER REPLACING THE MICROPROCESSOR, ETC.

The procedure after replacing the u-COM (microprocessor), flash ROM, etc. is as follows.
PCB Name Ref. No.
U1018 R5F56108VNFP 32BIT
HDMI
U1020 R5F5210ABDFP
HDMI
HDMI U1025 MX25L1606EM2I-12G 16M
U1027 MX25L12835FMI-10G 128M
HDMI
U1041 5M80ZT100C5N TQFP100
HDMI
HDMI U1045 5M80ZT100C5N TQFP100
Procedure after Replacement
A : The software has been written. The software is not written at the time of replacement.
B : The software has been written. The software may need to be rewritten by version updates. Check the version.
C : The software has not been written. The software needs to be written after replacement.
See "Firmware Update Procedure" for information on writing the software.
D : The software has been written. Be sure to rewrite with the latest software for your service region.
See "Firmware Update Procedure" for information on writing the software.

FIRMWARE UPDATE PROCEDURE

1. Updating by USB

The latest firmware can be downloaded to a USB memory for updates.
1.1. Connecting to the USB Memory
(1) Preparation
• USB format: Prepare a USB memory formatted in FAT16 or FAT32.
• Do not run the USB memory through a hub.
• Do not connect a computer to the USB port of this unit using a USB cable.
• Do not use an extension cable when connecting the USB unit.
1.2. Unzip Download File
Unzip the downloaded file on your computer.
SRXXXXXXX USB_SRXXXXXXX_XXXXXXXXXXXX-XXXX.zip
You can find "firmwares" folder after unzipped.
Copy that folder to USB flash drive.
You have to put "firmwares" folder on root directly on USB flash drive(memory).
Description
copy to USB flash drive
Proce-
dure after
Replace-
ment
SOFTWARE: Main
B
SOFTWARE: Sub
B
B SOFTWARE: DSP ROM
SOFTWARE: GUI ROM
B
SOFTWARE: AUDIO PLD
B
B SOFTWARE: VIDEO PLD
56
Remark