Spool Pin And Thread Mast; Machine Head Usb Port(Built-In) - Janome Quilt Maker 15 Instruction Manual

Spool Pin and Thread Mast

To install the Spool Pin on the machine
1. You'll need the spool pin with nut and washer.
2. Remove the nut and washer.
3. Place the washer against the top of the
machine cover.
4. Screw the nut onto the spool pin all the way.
5. Place the spool pin through the washer and
into the top cover and tighten it all the way.
6. Hold the spool pin firmly and tighten the nut
with the 8mm wrench (provided). Do not over
tighten.
Install the Thread Mast onto the machine
1. You'll need the thread mast with washer
and nut.
2. Remove the nut and washer.
3. Place the washer against the top of the
machine cover.
4. Screw the nut onto the thread mast all
the way.
5. Place the thread mast through the washer and
into the top cover and tighten it down to the
nut. Turn until the loop of the mast is directly
over the spool pin.
6. Hold the thread mast firmly and tighten the
nut with a 10mm wrench (provided). Do not
over tighten.
Machine Head USB Port (built-in)
The USB port is a full USB port that can be used to power a USB device, update the machine software, or
communicate with accessories. It is located on the side of the machine to the left of the display at the front.
janome.com
Page 13