Advertisement
1.- WHEN PURCHASING TWIN/FULL BOTTOM HDBD&FTBD, WE RECOMMEND YOU TO USE THE RAIL CAP (28-735)
2.- TO INSTALL THE RAIL CAP, PLACE IT AS FIG.D, MAKE SURE THE RAIL CAP IS INSERTED ON THE SIDE RAIL AND PUSHED TO THE HEADBOARD, SEE FIG.2
3.- ROLL THE TWIN/FULL BOTTOM HDBD&FTBD & PLACE IT BETWEEN LOFT DRESSER/HUTCH/TOP BUNK BED&LOFT DESK/HUTCH/TOP BUNK BED OR 1 PC BUNK BED END TWIN
BOTH CONFIGURATIONS.
AS SHOWN IN
NO TOOLS REQUIRED
1.- FOLLOW THE INFORMATION ON THE WARNINGS APPEARING ON THE UPPER BUNK END STRUCTURE AND ON THE CARTON. DO NOT REMOVE WARNING LABEL FROM BED.
2.- ALWAYS USE THE RECOMMENDED SIZE MATTRESS OR MATTRESS SUPPORT, OR BOTH TO HELP PREVENT THE LIKELIHOOD OF ENTRAPMENT OR FALLS.
3.- SURFACE OF MATTRESS MUST BE AT LEAST 5 IN BELOW THE UPPER EDGE OF GUARDRAILS.
4.- DO NOT ALLOW CHILDREN UNDER 6 YEARS OF AGE TO USE THE UPPER BUNK.
5.- PROHIBIT MORE THAN ONE PERSON ON UPPER BUNK.
6.-PERIODICALLY CHECK AND ENSURE THAT THE GUARD RAIL, LADDER AND OTHER COMPONENTS ARE IN THEIR PROPER POSITION, FREE FROM DAMAGE , AND THAT
ALL CONNECTORS ARE TIGHT.
7.- DO NOT ALLOW HORSEPLAY ON OR UNDER THE BED AND PROHIBIT JUMPING ON THE BED.
8.- ALWAYS USE THE LADDER FOR ENTERING AND LEAVING THE UPPER BUNK.
9.- DO NOT USE SUBSTITUTE PARTS. CONTACT THE MANUFACTURER OR DEALER FOR REPLACEMENT PARTS.
10.- USE OF A NIGHT LIGHT MAY PROVIDE ADDED SAFETY PRECAUTION FOR A CHILD USING THE UPPER BUNK.
11 .-IF THE BUNK BED WILL BE PLACED NEXT TO THE WALL THE GUARDRAIL THAT RUNS THE FULL LENGTH OF THE BED SHOULD BE PLACED AGAINST THE WALL TO PREVENT
ENTRAPMENT BETWEEN THE BED AND THE WALL.
12.- ALWAYS USE GUARDRAILS ON BOTH LONG SIDES OF THE UPPER BUNK.
13.- THE USE OF WATER OR SLEEP FLOTATION MATTRESSES IS PROHIBITED.
STRANGULATION HAZARD. NEVER ATTACH OR HANG ITEMS TO ANY PART OF THE BUNK BED THAT ARE NOT DESIGNED FOR USE WITH THE BED, FOR EXAMPLE
14.-
BUT NOT LIMITED TO HOOKS, BELTS AND JUMP ROPES.
15.- KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
THE UPPER&LOWER BUNK BED IS DESIGNED TO USE ONLY A MATTRESS WHICH IS 74" TO 75" LONG AND 37 1/2" TO 38 1/2" WIDE FOR TWIN BED.
WHEN THE LOWER BUNK BED IS A FULL BED, THE LOWER BUNK IS DESIGNED TO USE ONLY A MATTRESS WHICH IS 74" TO 75" LONG AND 52 1/2" X 53 1/2" WIDE.
THE BUNKIE BOARD IS REQUIRED TO 37 1/2" WIDE X 74" LONG FOR TWIN BED AND 52 1/2" WIDE X 74" LONG FOR FULL BED.
NOTE:
ENSURE THICKNESS OF MATTRESS AND FOUNDATION COMBINED DOES NOT EXCEED
BELOW UPPER EDGE OF GUARDRAILS.
REPLACEMENT PARTS, INCLUDING ADDITIONAL GUARDRAILS, MAY BE OBTAINED FROM ANY OF OUR CANYON FURNITURE COMPANY DEALERS.
REV 02 04/02/2019
CANYON FURNITURE COMPANY
RAIL CAP ASSEMBLY INSTRUCTION
RAIL CAP ASSEMBLY INSTRUCTION
FIG.1
SAFETY WARNINGS
SIZE OF MATTRESS AND FOUNDATION
REPLACEMENT PARTS
PAGE 5 OF 5
FIG.D
FIG.2
10"
AND MATTRESS IS AT LEAST
KIS01179-0
5"
Advertisement
