Advertisement
1.- ALIGN THE PRE- DRILLED HOLES IN LONG PART OF METAL HOOKS BRACKETS (O) WITH THE PRE- DRILLED HOLES IN THE LADDER (N), SECURE WITH 1" SCREWS (P) USING
PHILLIPS HEADSCREWDRIVER (NOT INCLUDED) , SEE FIG.B & HOOK THE LADDER IN THE PROPER POSITION, ADJUST AND ALIGN THE PRE-DRILLED HOLES IN THE SHORT
PART OF METAL HOOKS ON TOP GUARDRAIL AND SECURE THE LADDER, AS SHOWN IN FIG.13
FIG.13
1.- ASSEMBLE TWIN/FULL BOTTOM HDBD&FTBD, USING ONE HEADBOARD (K), ONE FOOTBOARD (L) AND TWO SIDE RAILS (F).
2.- INSERT TWO CROSS DOWEL NUTS (I) IN ACCESS HOLE INSIDE THE SIDE RAIL, ALIGN THE CROSS DOWEL NUT,MAKE SURE THE GROOVE IS HORIZONTAL, SEE FIG.1
3.- ATTACH THE HDBD&FTBD INTO THE SIDE RAILS, INSERTING TWO FLAT HEAD BOLTS (H) INTO THE HEADBOARD &FOOTBOARD HOLES, USE THE 5MM ALLEN WRENCH (J) TO
TIGHTEN BOLTS UNTIL SECURE, SEE FIG.2
4.- PLACE FOUR SLATS (Q) ON SIDE RAIL CLEATS, ONE SLAT IN BOTH ENDS, PUSH THE SLAT AGAINST THE BED END POST (FIG.A) AND TWO SLATS IN THE MIDDLE AT EQUAL
DISTANCE FROM THE END SLATS, THEN EACH SLAT MUST BE FASTEN WITH TWO 1 1/4" SCREWS (R), SEE FIG.3
5.- INSERT THE CASTER SOCKETS (M) INTO BOTTOM CORNERS OF THE HEADBOARD&FOOTBOARD, SEE FIG.C
6.- ROLL THE TWIN/FULL BOTTOM HDBD&FTBD&PLACE IT BETWEEN LOFT DRESSER/HUTCH/TOP BUNK BED &LOFT DESK/HUTCH/TOP BUNK BED OR 1 PC BUNK BED END TWIN
ALL OPTIONS
AS SHOWN IN
YES,
HORIZONTAL GROOVE
FIG.1
FIG.C
REV 02 04/02/2019
CANYON FURNITURE COMPANY
LADDER ASSEMBLY INSTRUCTIONS
TWIN/FULL BOTTOM HDBD&FTBD ASSEMBLY INSTRUCTIONS
NO
FIG.2
FIG.3
PAGE 4 OF 5
CASTER TWIN BED BOX ( 90-707,90-709 )
K.- (1) 3 DRAWER NIGHT STAND
FIG.B
CASTER TWIN BED BOX ( 90-707,90-709 )
M.- (1) CASTER BED HEADBOARD
N.- (1) CASTER BED FOOTBOARD
O.- (4) METAL CASTER SOCKET
J.- (6) 1 1/4" SCREW
KIS01179-0
FIG.A
Advertisement
