Table of Contents
Advertisement
PART 7
APPROVALS INFORMATION
7.1 CE APPROVAL
This product conforms to the EMC directive 89/336/EEC amended by
93/68/EEC, and with the European Low Voltage Directive 72/23/EEC.
Electrical Safety EN61010-1:2001
Safety requirements for electrical equipment for measurement, control and laboratory.
Basic Insulation
Pollution Degree 2
Dielectric withstand Test per 1 min
• Input Power to Ethernet Output:
• Input Power to I/O lines (DB9):
Measurement Category I
Category I are measurements performed on circuits not directly connected to the Mains
Supply (power).
Transients Overvoltage Surge (1.2/50uS Pulse)
• Input Power:
• Ethernet:
Note:
The ac/dc power adapter must have Safety Qualified Agency Approvals
for CE with Double Insulation rating.
The ac/dc power adapter is 9Vdc.
The minimum output current rating is 500mA.
EMC EN61000-6-1:2001 (Immunity) and EN61000-6-3:2001 (Emissions)
Immunity requirements for residential, commercial and light-industrial environments
• EMC Emissions
• EMC Immunity
EMC EN61326:1997 + and A1:1998 + A2:2001
Immunity and Emissions requirements for electrical equipment for measurement, control
and laboratory.
• EMC Emissions
• EMC Immunity
Note:
I/O lines (DB9) require shielded cables and these cables must be located on
conductive cable trays or in conduits. Furthermore, the length of these cables
should not exceed 30 meters
Refer to the EMC and Safety installation considerations (Guidelines) of this manual
for additional information.
7.2
FCC
This device complies with Part 15, Subpart B, Class B of the FCC rules.
1500Vac
none
500V Transients Overvoltage
1500V Transients Overvoltage
Table 1, Class B
Table 1: Enclosure
Table 2: Signal Lines Ports
Table 3: Dc input/Dc output Ports
Table 4, Class B of EN61326
Table 1 of EN61326
58
Advertisement
Table of Contents
