Sony NEX-7 Service Manual page 17

3-1. ASSEMBLY
Assembly-1: Screw tightening sequence when assem-
bling the Heat Sink (IM).
3
2
1
Radiation plate (IM)
Assembly-2: IM Adjust Washer (A, B, C) putting
position.
Cabinet (Front)
Assembly-3: Screw tightening sequence when
assembling the MB N Plate A (754).
MB N Plate A (754)
3 2
4
1
NEX-7/7K_L2
3. ASSEMBLY
Assembly-4: Method of attachment of MB Mask Sheet
(754).
Note: There should not be any misalignment when attaching
MB Mask Sheet (754).
J-6082-735-A
MB N Plate A (754)
Mask Sheet
Adhesive Sheet
Cabinet Front Block
Assembly-5: Apply grease on the MB N Plate SP.
MB N Plate SP
G G-85
(J-6082-626-A)
Assembly-6: Installation Cautions of the Flexible Re-
tainer (LC) (600).
Install the Flexible Retainer (LC) (600) while inserting four claws.
Flexible Retainer
Claws
(LC) (600)
Assembly-7: Installation Cautions of the Lock Claw
(LC).
Install the lock Claw (LC) while inserting claw and boss.
Lock Claw (LC)
Boss
Claw
3-1
Assembly-8: Installation Cautions of the ST Unit
(75600).
ST Unit (75600)
Claws
Claw B
Claw A
Assembly-9: Installation Cautions of the Rec Button.
Install the Rec Button as shown.
Rec Button
Pass the harnesses.
Bottom Side
Check to fit claw A
Rec Button
Gate