Table of Contents
Advertisement
Adjustments and Settings Using Menus (continued)
Audio Input
Assigns the audio input terminal for the video input that is
currently selected. Change the video input selection to
enable assignment for other inputs.
Setting Values: Off, Digital 1-4, Analog, HDMI
Default Value:
Digital 1 (Component 1), Digital 2 (S-Video 1),
Digital 3 (S-Video 2), Digital 4 (Component 2),
Analog (Video 1)
● The audio input for HDMI is normally assigned to the same
terminal. However, it is also possible to assign other audio
input terminals.
AV Lip Sync
This unit delays the output of audio input to ensure
synchronization with delays in video signals due to image
processing. The amount of audio delay can be adjusted.
Delay values can be set in units of milliseconds.
Setting Values: 0-200
Default Value: 0
● Upon selecting the menu, the current delay setting is
displayed.
● Delay time cannot be set to a negative value.
.................................................................................................
PICTURE CONTROL
Adjusts the output image quality.
Brightness
Adjusts the brightness of the image.
Setting Values: -100-100
Default Value: 0
● Increasing the value changes the color from black to gray.
Contrast
Adjusts the contrast of the image.
Setting Values: -100-100
Default Value: 0
Saturation
Adjusts the color density of the picture image.
Setting Values: -100-100
Default Value: 0
Hue
Adjusts the hue of the image.
Setting Values: -100-100
Default Value: 0
● Component (YPrPb) signals and PAL/SECAM signals
cannot be adjusted.
22
Sharpness(Comp)
Adjusts the outline of the image.
Setting Values: -100-100
Default Value: 0
Y/C Delay
Delay may arise between the brightness signals (Y) and
color signals (C), depending on the S-video signal input.
This may cause smudges to appear in the image. This is
because the delay leads to improper overlapping between
the color component and the black-and-white brightness
component. This unit corrects the time error (delay)
between these input signals by adjusting the phase of the
brightness signals according to the color signals.
Setting Values: -5-5
Default Value: 0
CUE-Correction
Reduces symptoms such as smudging or discoloration
(CUE: chroma upsampling error), which occur when
MPEG encoded video signals are inappropriately
decoded. Set to Auto if you are not sure whether CUE
is found in the input signals.
Setting Values: Off, On, Auto
Default Value: Off
● Off: When CUE is not found in the input signals.
● On: When CUE is found in the input signals.
● Auto: Automatically detects and reduces errors.
.................................................................................................
CONFIGURATION
Sets the operating mode of this unit.
Test Patterns
Sets the test pattern in this unit.
● Use the [TEST PATTERN ON/OFF] button on the remote
control unit to select whether to display or hide the test
pattern.
Auto Standby
When this is set to On , the processor switches
automatically to the standby mode after 30 seconds when
no signals are sent to the selected input terminal.
Setting Values: Off, On
Default Value: Off
Advertisement
Table of Contents
