Basic Operation Procedures
Setting the Output
The factory settings of this unit are as follows.
● Input terminal selection: Auto (Detects input signals sent to the input terminal automatically.)
● Output terminal selection: HDMI (Digital) (Outputs as RGB 4:4:4 signals.)
Follow the procedures below to set the output if the screen does not appear when in the default state.
● It may take a while to display the screen upon input of a HDCP signal.
Set using the remote control or buttons at the front of this unit while monitoring the LCD.
Buttons on this unit
● Press the [EXIT] button when an erratic operation is performed. Alternatively, press the [MENU] button to exit the menu,
then you will be able to repeat the operation from the beginning.
Press the [MENU] button.
● The menu appears on the LCD.
MAIN MENU
INPUT SELECT
Press the [J] button.
MAIN MENU
OUTPUT SETUP
Press the [ENTER] button.
OUTPUT SETUP
Analog/Digital
Press the [ENTER] button.
Analog/Digital
BNC (Analog)
Press the [K] button to select HDMI
(Digital) .
Analog/Digital
HDMI (Digital)
Press the [ENTER] button.
OUTPUT SETUP
Analog/Digital
18
Remote control
MENU
EXIT
ENTER
BORDER
CROP
Press the [K] button.
OUTPUT SETUP
Format
Press the [ENTER] button.
Format
420p
Press the [K] button a few times to
select 1080p-60 or 1080p-50 .
● Select 1080p-60 when the input signal is NTSC.
● Select 1080p-50 when the input signal is PAL/
SECAM.
Format
1080p-60
Press the [ENTER] button to confirm
selection.
Press the [MENU] button to end the
setting.
● The display on the LCD disappears.
(The processor exits the setting mode automatically
and the display disappears when no operation is
performed for about 30 seconds.