Turning On The Power - JVC LD-HD1KE Instruction Manual

Turning on the power

Before plugging in the power cord, ensure that all devices have been connected.
Precautions Against Fire and Electric Shock
● When not using devices, remove the power plug from the wall outlet.
● Do not use power cords for connection other than those supplied.
● Do not use AC adapters for connection other than those supplied.
● Do not use a power voltage different from that which is indicated.
● Do not cut, tear or modify the power cords. Also, do not place a heavy object on, heat or stretch the power cords as this
may cause damage to the cords.
● Do not modify or disassemble the AC adapter.
● Do not use the supplied AC adapter on other devices.
● Do not insert or pull out plugs with a wet hand.
● Do not allow dirt or metal to adhere to the power plug.
● When the electricity is turned on, do not cover the AC adapter with a rug or place it near equipment emitting heat, such
as heaters.
● Do not use with the power plug and AC adapter, or the AC adapter and this unit not properly connected.
● Be sure to plug the power plug firmly into the outlet.
Connect the AC adapter output cord to the [DC In]
terminal of this unit.
Attach the power cord to the AC adapter
Insert the power cord into the power outlet
● The following message is displayed on the LCD for about 3 seconds.
JVC LD-HD1K
Powered by ABT
Perform the following procedures to switch this unit to the operating mode
if the Status LED does not light up.
Turn on the power by pressing the Power/Standby
button on this unit
● The Status LED lights up in red.
Turn on the power of the input source.
Press the [H/I] buttons to select the input source
● The Status LED lights up in blue when signals are detected.
17