Planar Dome C3i Reference Manual page 22

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Display
Package Contents
Identify Components
Position Display
Desk Stand Features
INSTALLING THE DISPLAY
Set DIP Switch
Install Display Controller
Connect Video and Power
Install Display Driver
Change Display Properties
Dome CXtra Software
APPENDIXES
Troubleshooting
Specifications
LED Status Lights
Single Desktop
USB Connection
Component Removal
Power Management
Palette Options
Troubleshooting
Problem Possible cause
No image appears on Computer is not powered on.
the screen
Power cord is not securely connected.
Video cable connected incorrectly.
Power LED is amber Display is in DPMS mode.
No active signal coming from computer.
Signal cable is not fastened securely.
Computer video signal is not VESA DPMS
standard.
"Check video cable" message Video cable is not securely fastened.
VGA not enabled Incorrect DIP switch settings.
Dome C3i Display
Solution
Turn on computer.
Tighten power cord connection and turn on computer.
Make sure the first display of a dual-headed system or the
only display of a single-headed system is connected to the
Video 1 port on the DX2 display controller. (See
Turn off DPMS mode.
Turn off computer and secure connections.
Turn off computer and secure connections.
Use a VESA DPMS-compliant computer or video controller.
Turn off computer. Check and secure connection.
Check computer power and graphics adapter configuration.
You may need to remove the DX2 display controller to check
the DIP switch settings. You can enable VGA on the DX2
display controller or use a separate VGA card. See
for the correct switch positions to enable or disable VGA,
depending on your system.
page 9.)
page 7
14