Control Panel Buttons And Led Indicators - ASROCK iEPF-9000S-EX4 User Manual

2.1.1 Control Panel Buttons and LED Indicators

Power Switch
Press the power switch button to toggle the system power-on and power-off modes. To
remove all power from the system completely, disconnect the power cord from the system.
ClearCMOS Button
Use this button to manually reset the system. Press and hold the reset switch for a few
seconds to reboot the system without shutting it off.
Remote Power On/Off Switch (IGN connector)
This switch is for ignition power control and operation. Use this switch to remotely
monitor or turn on/off the ignition signal for in-vehicle applications, for instance.
Ethernet Port LED
There are two LEDs on the LAN port. Please refer to the table below for the LAN port LED indications.
Activity / Link LED
Status Description
Off No Link
Blinking Data Activity
On Link
PoE 1 Port Status LED
Status Description
Solid Green PoE 1 Port is connected to a PoE device
Off No PoE onnection
PoE 2 Port Status LED
Status Description
Solid Green PoE 2 Port is connected to a PoE device
Off No PoE connection
LAN Port
SPEED LED
ACT/LINK LED
Speed LED
Status
Off
Orange
Green
iEPF-9000S-EX4 / iEPF-9002S-EX4 /
iEP-9000E / iEP-9002E
Description
10Mbps connection
100Mbps connection
1Gbps connection
27