MULTIQUIP QP-40TE Operations & Parts Manual page 19

6. Grasp the starter grip (Figure 12) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
Figure 12. Starter Grip
7. If the engine has started, slowly return the choke lever
(Figure 13) to the CLOSED position. If the engine has not
started repeat steps 1 through 6.
Figure 13. Choke Lever (Closed)
8. Before the pump is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a lose component.
9. To begin pumping, place the throttle lever (Figure 14) in the
" RUN "position.
Figure 14. Throttle Lever (Run)
QP- 40TE — OPERATION & PARTS MANUAL — REV. #0 (04/13/05) — PAGE 19
QP- 40TE — INITIAL START-UP (ENGINE)
CAUTI CAUTI CAUTION CAUTI CAUTI
ALWAYS run engine at full speed while pumping.
Stopping The Engine
Normal Shutdown
1. Move the throttle lever to the IDLE position (Figure 15) and
run the engine for three minutes at low speed.
Figure 15. Throttle Lever (Idle)
2. After the engine cools , turn the engine ON/OFF switch to the
"OFF" position (Figure 16).
Figure 16. Engine ON/OFF Switch (OFF)
3. Place the fuel shut-off lever (Figure 17) in the OFF
position.
Figure 17. Fuel Valve Lever (OFF)
Emergency Showdown
1. Move the throttle lever quickly to the IDLE position, and place
the engine ON/OFF switch in the OFF position.