Red Light Cameras; Controlled Traffic Direction; Speed Limit Checked - Clarion MAP670 Owner's Manual

Note: In the rare case Clarion cannot register the mom ent you pass the second
camera (e.g. it is placed at the exit of a tunnel where GPS position is not yet
available) the warning will continue. Just tap the camera symbol displayed on the
screen to stop the warning.
These cameras are displayed with the following symbol:

4.9.1.5 Red light cameras

These cameras check if you obey traffic lights or not. The warning is similar to fixed
cameras, but as there is no speed limit given, only the proximity is announced.
These cameras are displayed with the following symbol:

4.9.2 Controlled traffic direction

The different cameras can measure the speed of one direction of the traffic, both
directions, or even se veral directions in an intersection, when they are mounted on a
rotating base. Clarion warns you only if you drive in a meas ured or possibly
measured direction.
The measured direction of the cameras is displayed with the following symbols:

4.9.3 Speed limit checked

As additional information, the speed lim it che cked by the camera is given for fixed,
built-in and section control cameras. When you manually save a camera location
from the Cursor menu (Page 35), the speed limit of the road (if available) is used by
default, but you can change this value with the given control:
59