Common Operations; Setting The Clock; Turning On The Power And Selecting The Sources - JVC SP-MXJ100J Instructions Manual

Common Operations

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
• If you want to stop clock setting, press CLOCK/TIMER
once or wait until the time limit of 15 seconds comes.
1
Press CLOCK/TIMER twice.
The "CLOCK" appears on the display.
2
Press PROGRAM/SET.
The hour digits start flashing on the
display.
Press 4 or ¢ to adjust
3
the hour, then press
PROGRAM/SET.
After hour digits are set, the
minute digits start flashing on the
display.
Press 4 or ¢ to adjust
4
the minute, then press
PROGRAM/SET.
5
Press CLOCK/TIMER twice to
finish the clock setting.
To check the clock time
Press CLOCK/TIMER while playing any source.
The clock time appears on the display
for a while.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER until the "CLOCK" is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
The clock loses the setting and is reset to "AM 12:00." You need to
set the clock again.
CLOCK/TIMER
Turning On the Power and Selecting the
Sources
When you press the play button for a particular source (AUX,
FM/AM, CD 6, and TAPE 3), the unit turns on (and the
PROGRAM/SET unit starts playing the source if it is ready — COMPU PLAY
CONTROL).
To listen to the FM/AM broadcasts, press FM/AM. (See
page 11.)
To play back CDs, press CD 6. (See pages 12 – 13.)
To play back tapes, press TAPE 3. (See page 14.)
To select the external equipment as the source, press AUX.
AUX
To turn on the unit without playing, press
PROGRAM/SET
POWER so that the STANDBY lamp goes off.
To turn off the unit (on standby), press
POWER again so that the STANDBY lamp
lights up.
PROGRAM/SET
CLOCK/TIMER
A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
CLOCK/TIMER
power cord from the AC outlet.
The clock is reset to "AM 12:00" right away, while the tuner preset
stations (see page 11) will be erased in a few days.
– 9 –
Clock time CLOCK
‰ REC
‰ TIMER
If there is a power failure
FM/AM
CD
When you unplug the AC power cord or if a power
failure occurs
TAPE
STANDBY
POWER
STANDBY
POWER