JVC RX-E100RSLB Instructions Manual page 20

Crossover Frequency — CROSS
Small speakers cannot reproduce the bass sounds efficiently. If you
use a small speaker in any position, this unit automatically
reallocates the bass sound elements assigned to the small speaker to
the large speakers.
To use this function properly, set this crossover frequency level
according to the size of the small speaker connected.
• If you have selected "LRG (large)" for all speakers, this function
will not take effect.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
SETTING
settings.
2
Press CONTROL ∞ (or 5) repeatedly until
"CROSS (Crossover)" (with the current setting)
appears on the display.
CONTROL
GIC
UTO
TT
* "100HZ" is the initial setting. If you have already changed the
setting, another frequency will be shown.
3
Press CONTROL 3 (or 2) to select the crossover
frequency level.
• Each time you press the button, the crossover frequency level
changes as follows:
CONTROL
ANALOG L C R PRO LOGIC
LPCM DSP
SUBWFR LFE
DGTL AUTO
DOLBY D
LS S RS
DTS INPUT ATT
• Use the following criteria as reference when adjusting:
80HZ
: Select this frequency when the cone speaker unit
built in the speaker is about 4
100HZ : Select this frequency when the cone speaker unit built
in the speaker is about 3
120HZ : Select this frequency when the cone speaker unit
built in the speaker is about 3
*
VOL
VOL
3
/ inches (12 cm).
4
15
/ inches (10 cm).
16
3
/ inches (8 cm).
16
Dynamic Range Compression — D.R.C.
You can compress the dynamic range (difference between maximum
sound and minimum sound) of the reproduced sound. This is useful
when enjoying surround sound at night.
• This function takes effect only when playing back a source using
Dolby Digital.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
SETTING
settings.
2
Press CONTROL∞ (or 5) repeatedly until
"D.R.C. (Dynamic Range Compression)" (with
the current setting) appears on the display.
*
CONTROL
IC
TO
T
* "MID" is the initial setting. If you have already changed the
setting, another setting will be shown.
3
Press CONTROL 3 (or 2) to select the
appropriate compression level.
• Each time you press the button, the compression level changes
as follows:
CONTROL
ANALOG L C R PRO LOGIC
DSP
LPCM
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
OFF : Select this when you want to enjoy surround with its
full dynamic range. (No effect applied.)
MID : Select this when you want to reduce the dynamic range
a little.
MAX : Select this when you want to apply the compression
effect fully. (Useful at night.)
TO BE CONTINUED TO THE NEXT PAGE
VOL
VOL
17