Advertisement
!CAUTION: Hydraulic oil is highly flammable.Keep away from
sparks and naked flame.Do not smoke.
!CAUTION:Hydraulic oil may cause inflammation of the eyes and
skin.If ingested,it will cause diarrhoea and vomiting. In case of eye
contact, rinse
physician.
In case of skin contact, wash thoroughly with soap and
water. In case of ingestion, consult a physician
immediately. Do not Deliberately induce vomiting.
1. Oil should be warm but not hot. Warm up unit if cold.
2. Adust stopper and make three or four cuts, noting exactly at what point
the Rebar is actually breaking.
3. Pinch a short piece of rebar,stopping just before it breaks off. Unplug
unit From power source.
4. with partially severed rebar in place, turn unit over so that oil-plug is
uppermost. ( If unit is hot,allow to cool down.)
5. Remove oil-plug and seal-washer (packing).
!CAUTION: Never remove oil-plug when unit is hot or oil will spurt out.
6. Check that oil is level with bottom of plug hole(i.e. that pump case is full
to The brim). If oil level is too low,top up with 20-weight hydraulic oil
with Anti-foam and anti-abrasion properties (ISO viscosity grade VG46,
e.g. Shell Oil Tellus 46, Mobil oil DTE-25 or Esso Uni power SQ46 ).
in clean water for at least 15 minutes And consult a
11
Advertisement
