Denon HEOS HomeCinema HS2 Service Manual page 54

2. Service Release Type settings update procedures
Copy the Service Release Type settings from the USB flash drive to this unit.
2.1. Items to Be Prepared
・ Windows PC
・ USB flash drive format : Prepare a USB flash drive formatted in FAT16 or FAT32.
NOTE：
・ Do not run the USB flash drive through a hub.
・ Do not connect a computer to the USB port of this unit using a USB cable.
・ Do not use an extension cable when connecting the USB flash drive.
・ If a USB flash drive cannot be updated, replace it with a different USB flash drive and perform
the update again.
2.2. Creating a Service Release Type Settings file
(1) Click [Start button] - [Accessories] - [notepad] on the PC to launch the notepad.
(2) Enter "TEXT".
(3) Click "File", and then click "Save As...".
(4) Enter the file name "aios-config-release-type-set-3" and click the Save button.
NOTE : Enter the file name in double quotation marks. (The file extension is not required.)
"aios-config-release-type-set-3"
(5) Copy the files created on the USB flash drive.
2.3. Inserting a USB flash drive in the USB port
(1) Insert a USB flash drive containing the file created by the above procedure into the USB port on the
back panel of this unit.
(2) Check that the LED on the front panel of this unit is blinking, then remove the USB flash drive from
this unit.
The Service Release Type settings are now complete.
54
copy to USB flash drive