Denon HEOS HomeCinema HS2 Service Manual page 51

8. When connecting to network (Setup Assistant)
The following transition occurs during connection to the network. Refer to "QSG".
Press "Connect" but-
Not connected lished between HEOS
ton.
Amber : Solid Green : Blinking
9. Bluetooth
The following transition occurs when the "Bluetooth" button is pressed.
Bluetooth Pairing enabled Pairing successful
Green : Blinking Twice Blue : Blinking Once
Repeated Repeated
Pairing failed
Red : Solid (7sec.)
Status LED
Connection estab- When network
Connected to the
connection setup is
network
and smartphone
Green : Solid Blue : Blinking
Time-out
Red : Solid (7sec.)
10. Standby
The following transition occurs when this unit switches to standby.
Network con-
nected
complete
Blue : Solid
Blue : Solid
Not connected
Amber : Solid
Connected to the
network
11. Volume button and Mute button
The indicators are lit as shown below when the "Volume" button and "Mute" button are pressed.
"Volume" button
Blue : Fast Blinking
12. Submit Diagnostics
The following transition occurs when "Submit Diagnostics" is performed from the HEOS app.
Operations in HEOS app : Settings - Advanced - Submit Diagnostics
Network connected
Blue : Solid
51
Connect in Status LED
Quick Start mode
No access over
20 min.
Blue : Solid
(Dimmer)
Access from app
Not connected
No access over
20 min.
Amber : Solid
Access from app
"Mute" button
Blue : Slow Blinking
Sending diagnostic data
Purple : Blinking
Time out in HEOS app
Red : Blinking Once
Deep Standby
60 min. later.
LED : Off
Button operation
Diagnostic data sent
Blue : Solid