Table of Contents
Advertisement
Setting
Setting Using Internet
Explorer (continued)
Motion Detection Page (continued)
A
Display Screen
B
Detection
C
OK/Cancel
D
Level
E
Mask All
F
Clear Mask
Memo ：
● The area display position serves as a
reference. Ensure to perform operation
check.
● The screen is divided into 48 (8 x 6) blocks.
Set the angle of view such that multiple
blocks are used to set the size of the object
for motion detection.
54
The screen is divided into blocks of 8 x 6. Use this to set whether to mask
each block.
All blocks are masked in the default setting.
The block turns blue when it is clicked, indicating that it is unmasked. Click
again to return to the masked state.
Press the [OK] button to enable this setting.
Use the [Mask All] button to mask all blocks.
Use the [Clear Mask] button to unmask all blocks.
For setting motion detection to On/Off.
Press the [OK] button to enable this setting.
To enable the new parameters, press the [OK] button. Press the [Cancel]
button to cancel the change.
For setting the sensitivity of motion detection.
When the number is large, the detection sensitivity rises and hence it is
sensitive.
Press the [OK] button to enable this setting.
Masks all blocks and enables the current motion detection and detection
sensitivity settings.
Press the [OK] button to enable this setting.
Unmasks all blocks and enables the current motion detection and detection
sensitivity settings.
Press the [OK] button to enable this setting.
Note ：
● Flicker of fluorescent lights may cause
malfunction during motion detection.
● Changes in brightness due to lighting may be
detected as motion.
● The motion detection feature is not intended
to prevent theft or fire. This feature may not
function properly depending on the
conditions of the object and settings.
JVC shall not be liable for any accident or
damage that occurs.
Advertisement
Table of Contents
