Table of Contents
Advertisement
LX-D700U/E.Q33E 6/3/98 3:48 PM Page 20
Connection of Power Cord
Plug in the projector power cord after the connection of components is completed. Connection of the power cord
powers the unit instantly with an operation indicator lighting up in orange. Connection of the power cord is recom-
mended after the completion of connection and installation of components to this unit.
1 Insert the concave side of the power cord into the power cord connecting socket of the main unit.
2 Insert the plug of the power cord into the outlet.
Use the power conversion plug matching the outlet shape.
Observe the following. Otherwise, fire, electric shock, and injury can result.
• The unit enters into a powered state when the power cord is connected. When components are not used,
unplug the power cords of the components from the outlets.
• Do not make connection with a cable other than the accessory cable.
• Do not apply a power supply voltage other than the specified voltage.
• Do not damage, break, and modify the power cable. The power cable can also be broken if you put a heavy
object on it, or heat it, or tug at it.
• Do not engage in plugging and unplugging with wet hands.
If the indicators make following indications, take necessary measures on each of them. Leaving them unheed-
ed can result in mechanical failure and fire.
Warning Indication by Indicators
Operation Indicator
Blinking of Orange or Light-up of Red
The inside of the unit reached abnormally high
temperature. It is probable that the air filter of
the cooling fan is soiled or the air outlet of
the cooling fan is blocked. Clean up the air filter or remove the obstacle that blocks the air outlet. Note also that the working
temperature range of this unit is between 42°F/5°C and 104°F/40°C. Check the ambient temperature and make adjustment
so that the ambient temperature comes within this temperature range. Unplug the power cord from the outlet immediately if
the symptom persists, and contact the store where you bought the unit or the nearest JVC Service Center.
Blinking of Red
Unplug the power cord from the outlet immediately and contact the store where you bought the unit or the nearest JVC
Service Center.
20
Power cord (accessory)
Outlet AC 100-120V
WARNING
CAUTION
Lamp Indicator
Alternate Blinking of Orange and Red
Service life of a lamp is nearing the end. You must either make prepara-
tions for a new lamp or replace it with a new lamp. This indicator blinks
for 5 minutes every time the power is turned on. Furthermore, this indi-
cation takes place when the lamp nears the end of its service life during
projection. This warning is displayed on-screen as [LAMP REPLACE ]
for about 30 seconds.
Light-up of Red
Expiration of the lamp's service life has come. At the same time, you
cannot turn on the power. Replace it with a new lamp.
Blinking of Red
Lamp or the power supply for the lamp is abnormal. Check out the
installed lamp again. Unplug the power cord from the outlet if the symp-
tom persists, and contact the store where you bought the unit or con-
tact the nearest JVC Service Center.
50/60 Hz
Advertisement
Table of Contents
