Adjusting The Volume; Reinforcing The Bass Sound - JVC FS-MD9000J Instructions Manual

Adjusting the Volume

You can adjust the volume level between 0 and 50.
The VOLUME indicator on the display indicates the volume level.
VOLUME
Press the VOLUME UP button of the Unit to increase the volume or
press the VOLUME DOWN button to decrease it.
Press the VOLUME + button on the Remote Control to increase the
volume or press the VOLUME - button to decrease it.
CAUTION: DO NOT start playing any source with-
out first setting the VOLUME control to minimum
position, as a sudden blast of sound can damage
your hearing, speakers and/or headphones.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers.
Be sure to turn down the volume before connecting or putting on
headphones.

Reinforcing the Bass Sound

(AHB SUPER PRO)
You can reinforce the bass sound to maintain rich, full bass at low
volume (you can use this effect only for playback):
To get the effect, press the AHB (Active Hyper Bass) SUPER
PRO button.
The "BASS" indicator lights up on the display.
To cancel the effect, press the button again.
The "BASS" indicator goes out.
Tone Control (BASS/TREBLE)
You can control the tone by changing the bass and treble.
BASS Control ———————————
You can adjust the bass level (low frequency range level) between
–6 and +6. (0: Flat)
1. Press the BASS button on the Remote Con-
trol.
2. Press the UP or DOWN button on the
Remote Control to adjust the bass level.
DOWN
TREBLE Control ——————————
You can adjust the treble level (high frequency range level) between
–6 and +6. (0: Flat)
1. Press the TREBLE button on the Remote
Control.
2. Press the UP or DOWN button on the
Remote Control to adjust the treble level.
DOWN
OR
BASS
UP
TREBLE
UP
The bass or treble level display goes out when the BASS or
TREBLE button is pressed again or when nothing is done for
about 6 seconds.
Showing the Time (CLOCK)
In Standby mode, the clock appears on the display.
When the System is turned on, you can display the clock at any time.
To display the clock, press the CLOCK button.
To light off the clock, press the CLOCK button again.
Note: To let work the clock, you need to set the clock beforehand.
(See "Setting the Clock" on page 20.)
7